Radwin 5000

RADWIN5000ConfigurationGuide Release4.9.17 B‐1
AppendixB:Oper atingUnder
theFCCUnrestricted
ContentionBasedProtocol
B.1ScopeofthisChapter
ThisappendixexplainshowtosetupaRADWIN5000sectoroperatingundertheFCC
UnrestrictedContentionBasedProtocol(UCBP)inthe3.650‐3.7GHzband.
Thedetailedtechnicaloperationoftheprotocolisbeyondthescopeofthismanual.
B.2BringingupaSector
TheHBSforFCCUCBPispre‐configuredforthisregulationonly.
Activationisthe sameasforotherRADWIN5000products(seeToactivateanHBS:onpage 3‐
5).Followingactivation,theHBSwillfinditsHSUsinthesamemannerasdescri bedin
Chapter3.
TheonlyadditionalstepsyoumusttakearetosettwoextraparametersintheConfiguration
AirInterfacetab: