Chapter 6
88 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Alarms Area
Depending upon the alert or warning condition, the field computer may display one or more of the following
icons:
Touch any of the displayed icons to display information regarding the corresponding alarm.
• The Product Control Alarm icon is displayed if an alarm condition such as a low bin or tank, or when product
control cannot reach the target rate.
• The AutoBoom Alarm icon is displayed if an alarm condition such as sensors too low or high, the pressure
is higher than the set point, or if a sensor has gone off line. Refer to Chapter 10, Using AutoBoom®, for
more information about the optional Glide Series AutoBoom system and troubleshooting AutoBoom alarms.
• Touch the Show All Alarms icon to view all current alarm conditions.
Hiding the Alarms Area
Once the operator has reviewed any alert information, the Alarms area can be hidden to resume operation.
1. To hide the Alarms area, touch the green check
mark icon.
2. If the alarm condition still exists, an Alarm icon
appears on the screen until the alarm condition has
been cleared. Touch this icon to re-display the
Alarms area.
3. For help clearing alarm conditions, refer to Chapter
11, Troubleshooting, for product control
troubleshooting information. Refer to the CAN
AutoBoom
®
Calibration and Operation Manual for
information about using and troubleshooting the
optional Glide Series AutoBoom system or the
OmniRow
®
Calibration and Operation Manual for assistance with the OmniRow system.
Audible Alarms
Audible alarms are enabled by default. To disable the notification tone or change available alarm settings, see
the Alarm Settings section on page 116 to setup the Audible Alarms.
Product Control
Show All
AutoBoom
To Next Page
Loading...
