6
P/N 016-0171-493 Rev. I 83
Basic Operation
Drift Shift
Note:
The drift shift feature must be enabled prior to starting a job to allow the following features to be
available during the field operation. Refer to Drift Shift section on page 134 for assistance with the
drift shift settings.
Manual Coverage Adjustment
To manually adjust the reported position of all job features:
1. Touch the Menu icon in the lower, right corner of the guidance display.
2. Select the Drift Shift icon.
3. Use the fine and coarse nudge arrows on the screen to adjust the field features displayed to the actual
vehicle location. As the job features are adjusted, the cumulative nudge applied in each direction is
displayed in the lower, right corner of the display.
4. Touch the Menu icon and select the Accept button to accept the applied drift shift values and return to the
Field Review mode or Cancel to undo the applied shift adjustments.
To Next Page
Loading...
