Chapter 7
120 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
AutoBoom
®
Touch this icon to display the AutoBoom Setup screen. See Chapter 10, Using AutoBoom®, for a brief
overview of this feature on the Envizio Pro. Refer to the AutoBoom Calibration & Operation Manual for
calibration and detailed operation instructions.
Note: If no AutoBoom node is detected by the CANbus, a Function Disabled screen will appear.
Troubleshoot the node and readdress the CANbus. See Chapter 4, CAN Networking and
Diagnostics, for CAN installation and troubleshooting information.
Steering
If an optional assisted steering system has been installed, the Steering icon will be displayed in the System
menu. Touch this icon to access the Steering Settings screen. For more detailed installation and calibration
Information, refer to the SmarTrax Calibration and Operation Manual.
GPS Menu
The GPS menu displays available options for the DGPS source. The GPS menu contains the DGPS Source
selection options as well as settings for Message Outputs, Differential Sources, and a DGPS Status, or Health,
screen.
Note: The Source and Output screens are only available on consoles featuring the built-in receiver.
These screens are only accessible if the built-in receiver is selected as the source of DGPS signal.
Enable/Disable
Reverse Sensing
Feature
To Next Page
Loading...
