P/N 016-0171-493 Rev. I 109
Tools Menu
7
Calibration Settings
The Calibration Settings screen displays calibration values for the selected product and application type.
Touch the corresponding button to enter or modify a calibration value for the selected product node.
Note: For recommended methods of calculating various calibration values, refer to Appendix A,
Calculating the Calibration Values.
If the field computer is connected to the optional Raven OmniSeed system for seeder control
operations, refer to Appendix I, OmniSeed™ Calibration, for details on settings used with the
OmniSeed feature.
Meter Cal, Spinner Cal, or Product Density
• The flow meter calibration (meter cal) value can be found on the tag attached to the flow meter. Review the
Meter Cal section on page 191
Note: Copy the information from the tag for future reference as tags may fade or be lost during
operation.
• If operating in a granular application mode, the Product Density button replaces the meter cal value. Touch
the Product Density button to enter the measured product density.
• When controlling the spinner RPM with granular product applications, the spinner calibration setting will
replace the meter cal setting on the Calibration Settings screen.
Granular Control ModeLiquid Control Mode
To Next Page
Loading...
