P/N 016-0171-493 Rev. I 131
Tools Menu
7
Default Differential
The Default Differential screen replaces the Differential
screen if:
• any non-Raven external GPS receiver connected to
the field computer for position corrections.
• the field computer is not able to determine the type of
differential corrections provided for position
corrections.
• GPS messages are passed through a Raven TM-1
Tilt Module or SmarTrax steering system.
In any of the conditions outlined above, the Default
Differential screen allows the operator to manually set
the type of corrections being used for position
information and corrections.
Selecting the appropriate source of differential corrections allows the Envizio Pro to display the GPS Status
Icon as outlined in the GPS Status section on page 52. The Default Differential selection also allows the field
computer to identify and display potential GPS error conditions during field operations.
Important: Potential error conditions must be verified and addressed on the external receiver or the source setting
must be set to Internal to access the internal GPS receiver settings.
Output
Important: If a SmarTrax assisted steering system is connected to the Envizio Pro field computer, set the correction
source to internal before making changes to the Envizio Pro internal receiver.
To setup the type, frequency, and baud rate of message outputs from the built-in receiver, touch the Output
icon.
Note: The GPS Output screen is only available when using the internal GPS receiver. Message outputs
from an external GPS receiver must be setup through the external hardware.
Radar Output
Information Screen
To Next Page
Loading...
