Raven Envizio Pro - Creating an Accuboom Zone Map

Chapter 9
174 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Stop
When finished recording a Zone or Boundary, touch the Stop button to close Zone or Boundary.
Note: The field computer will draw a straight line from the starting point of the feature to the current
vehicle location when closing the zone map feature.
Creating an AccuBoom™ Zone Map
The following is an example of recording an AccuBoom field boundary in the zone mapping mode. Other zone
features may be recorded using the same procedure by using the buttons and tools as described in the
AccuBoom™ Mapping Tools section on page 173.
1. On the Guidance screen, access the Menu and select the AccuBoom Boundary Tools icon.
2. Select the Record Field Boundary button to begin recording a new AccuBoom field boundary.
Stop No-Spray
Zone
Stop Spray
Zone
Stop Field
Boundary
Record AccuBoom
Field Boundary