Chapter 5
44 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
9. The field computer also allows the operator to set and adjust the location of configured sections. For
standard configurations, such as a sprayer boom, a combine header or a single section implement, select
the Auto Configure button to automatically align sections end-to-end along the swath midpoint.
Note: Individual section locations may be manually modified after the operator has selected to
automatically configure the section locations.
For implement configurations where sections are staggered, overlapping or spread out, touch the Manually
Configure button to manually adjust the fore/aft and left/right offsets for each individual section. Refer to
Manually Configure Sections section on page 151.
Note: The offset distances represent the offset from the DGPS antenna to the center of the selected
section.
10. Select the Auto or Manually Configure buttons and then touch the Next icon to return to the Setup
Wizard Menu screen.
Product Control Setup Wizard
The product control setup wizard will require the following information for each product connected to the field
computer CANbus control system:
• Speed cal and sensor type
• Application type
• Valve cal and valve type
• Meter cal
• Rate cal
• Section assignments
Note: By default, the product controller node is set to provide two control channels for the field computer.
The initial configuration wizard will need to be completed before the number of control channels
may be modified.
To Next Page
Loading...
