Chapter 3
24 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Installing Optional Equipment
The following sections offer descriptions of optional hardware or configurations in which the Envizio Pro is
capable of operating.
Boom Sense Wire
The boom sense wire may be connected to the master switch functions of the machine to allow seamless
operation of vehicle master on/off and the field computer mapping feature.
If the boom sense wire is properly connected, the vehicle master on/off switch also toggles the product
coverage mapping based on a +12V signal detected on this wire.
Generation 1 Cabling
Connect the spade connector on the main interface cable (P/N 115-0171-746) labeled “Ext. Switch” (external
switch) to the machine master switch.
FIGURE 8. Main Interface Cable (P/N 115-0171-746) Boom Sense Wire Connection
Note: Contact the machine manufacturer for more information on connecting the boom sense wire on the
specific machine.
To Next Page
Loading...
