Chapter 5
42 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Setup Wizards
The setup wizards simplify the task of setting up the Envizio Pro control system for different products,
implements or vehicles. Each setup wizard will display a series of prompts for which settings and calibration
values will be required.
Setup Wizard Menu
After the initial setup is complete, a menu of the available setup wizards can be displayed by selecting the
wizard icon in the upper left corner of the Tools menu.
See Chapter 7, Tools Menu, for detailed descriptions of the other features accessible through the Tools menu.
The Setup Wizard Menu will display the available setup wizards which may be used to complete the initial
setup of the field computer.
Note: Depending upon previous options selected during the initial setup wizard, completion of some
wizards may be required before the field computer is ready for operation.
Only setup wizards which apply to the system will be displayed in the Setup Wizard Menu. For
example, if a Glide Series AutoBoom system is not present on the CANbus, the AutoBoom setup
wizard will not be displayed on this screen.
To launch a wizard, touch the icon next to the desired setup wizard to begin. Touch the Accept icon to exit
the Setup Wizard Menu.
Note: During the initial setup wizard, the Accept icon will be available only after all required wizards have
been completed.
Refer to the following sections for detailed instructions on completing the setup wizards.
To Next Page
Loading...
