5
P/N 016-0171-493 Rev. I 49
Startup, Initial Setup, and Setup Wizards
AutoBoom
®
Setup Wizard
If an optional Glide Series AutoBoom system has been installed, the AutoBoom setup wizard is available to
calibrate and verify system settings during the initial setup.
The AutoBoom setup wizard may require the following information:
• Pressure Set (PowerGlide Plus)
• Sensor Height and Sensor Height Offsets (UltraGlide)
• PWM Frequency and Minimum Pressure Percent
• Speed
• Sensitivity
• Stability Factor
Using the AutoBoom
®
Setup Wizard
Refer to the CAN AutoBoom Calibration & Operation Manual for more information regarding setup and use of
the Glide Series AutoBoom system.
To Next Page
Loading...
