P/N 016-0171-493 Rev. I 233
Section Setup
The section set up for most seeder systems will require manual entry of offsets for sections based upon the
relative location of seed control or any optional liquid sections.
Note: Review the Section Setup section on page 148 for details on using the Section Setup Wizard.
FIGURE 1. OmniSeed Granular and Liquid Section Configuration Example
To configure the seeder implement sections, use the Manually Configure option on the Configure Sections
screen.
When the section setup is complete for the seeder implement, the Section Configuration screen should display
an abstract layout of the seeder implement as shown in the figure below.
Example Granular
Product Section
Example Liquid
Product Sections
x
(‘x’ indicates
the midpoint of
each section)
xxxxx
To Next Page
Loading...
