APPENDIX
H
P/N 016-0171-493 Rev. I 223
A ppendi x H
Blockage Monitoring
Sensors
System Overview
With the optional blockage sensor system, the field computer is capable of monitoring seed or product flow
during field operations. If an obstruction is detected, the field computer will display information from the
sensors to help the operator quickly locate the obstruction.
During a field operation, the status of the blockage sensor system is displayed at the bottom of the Guidance
screen.
The field computer may be connected to two separate sensor loops with up to 120 sensors per loop to monitor
seed or product flow at various locations on the implement depending upon the level of system monitoring
desired.
Blockage Node Detection
If the blockage system is installed and correctly connected to the field computer, the blockage node should
display on the CAN Diagnostics screen. Refer to the CAN Diagnostics section on page 30 for details on using
CAN Diagnostics.
If the blockage node is not displayed on this screen, check the node connections and restart CANbus
communication. If the node is still not detected, contact a local dealer for assistance.
To Next Page
Loading...
