Chapter 2
4 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
This document is intended to provide information regarding the following aspects of the Envizio Pro field
computers:
• Installation
• Initial Setup and Calibration
• Basic Operation
• Updates and Feature Activation
• Advanced Features and Operation
Envizio Pro Features
The following descriptions offer a brief introduction to the capabilities of the Envizio Pro field computers and
some of the optional features available for use with each of these systems.
Speed Compensated Product Control and Datalogging
Envizio Pro field computers are capable of monitoring or controlling product application via either a serial or
CANbus rate control system.
Raven CANbus Control
The Envizio Pro field computers are capable of controlling up to four products or control channels through
product control nodes connected to a CANbus system. The field computer automatically adjusts the application
rate of each product according to the speed of the vehicle, width and status of programmed sections and a
programmed target rate.
With the optional variable rate application (VRA) feature, the Envizio Pro field computers are also capable of
controlling a single product according to a prescription map.
Note: An optional multiple product control key is required to enable control channels three and four on
the Envizio Pro and Envizio Pro II field computers.
A multi-product VRA key is available to unlock variable rate control features for multiple product
control channels. A single product VRA key is required to successfully authorize the multiple
product VRA key.
To Next Page
Loading...
