Chapter 7
132 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Message Types and Frequency
Use the sliding bar next to the desired message type to set the frequency of the output message. Messages
may be sent out at 0.2, 1, 5 or 10 Hz, depending upon the message. Set the slider to 0 Hz to turn the message
off.
Messages sent out of the built-in receiver are sent out of the connector labeled ‘GPS Out’ on the auxiliary
interface cable or chassis interface cable. Contact a local Raven dealer for more information.
Baud
Select the Baud Rate of the message strings sent from the built-in receiver.
Note: Some GPS or Assisted Steering components may require specific Baud Rate settings.
Simulated Radar Output
Touch the ‘Next’ icon displayed on the GPS Output screen to view the simulated radar output from the field
computer. These settings may be used to help set up an external device to receive GPS speed signal output
from the internal GPS receiver.
External Light Bar, TM-1 Tilt Module and SmarTrax™
If an optional SmarTrax system, external light bar or TM-1 Tilt Module is connected to the field computer, the
GPS Output Baud setting must be set to 19,200 before changing the Source selection. For more information
on the GPS Source settings, see the Source section on page 133.
To Next Page
Loading...
