Chapter 7
130 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Accuracy Warning
Touch the Accuracy Warning button along the right side of the screen and use the on-screen keypad to set the
allowable horizontal accuracy, in inches [centimeters], which will be allowed before the field computer will
provide a GPS accuracy warning or the GPS status shield will turn yellow during operations.
Note: Higher values will allow the receiver to converge faster, but will allow more horizontal position
error. Smaller values will provide more accurate position, but will take longer to converge and are
more likely to lose a converged status during field operations.
Slingshot
®
GS
If the Slingshot GS correction service is selected for differential corrections through the Slingshot wireless
network, the Differential screen will display the following options.
Accuracy Warning. The accuracy warning value sets the allowable horizontal accuracy for field operation.
When the field computer determines the position solution meets the set value, the solution will be
considered converged and the appropriate status will be displayed.
Note: Higher values will allow the receiver to converge faster, but will allow more horizontal position
error. Smaller values will provide more accurate position, but will take longer to converge and are
more likely to lose a converged status during field operations.
Baud Rate. Select the baud rate at which the correction messages are transmitted from the correction source.
The default baud rate setting is 115200.
To Next Page
Loading...
