Chapter 9
168 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
2. Touch the AccuControl button on the Verify Settings screen (See Chapter 6, Basic Operation, for details on
other settings and features enable on the Verify Settings screen).
3. Select the Enable AccuBoom option to allow the AccuBoom feature to automatically control boom or
implement sections. Leaving this option blank will disable AccuBoom. Once the Enable AccuBoom option is
selected, the AccuBoom screen will appear similar to the following:
4. Leave the ‘Enable Zone Map’ option deselected to use Standard AccuBoom section control only. See the
AccuBoom™ Modes section on page 169 for more information on the AccuBoom modes.
Touch the Accept icon and skip to step 7 if Standard AccuBoom is the desired mode of operation for this
job. Proceed to step 6 to select a zone map for this job.
5. Select the ‘Enable Zone Map’ option to enable the zone mapping mode.
To Next Page
Loading...
