6
P/N 016-0171-493 Rev. I 69
Basic Operation
In Job Product Configuration
Several product control settings and display options are available during a job by touching the rates area of the
Product Rate Display. The following screen is displayed:
The following information is displayed on this screen:
1. Application information
2. Selected product
3. Control mode
4. Target rate
5. Display options
Touch the green check mark to return to the Guidance screen.
To view and setup additional settings for each product, touch the green arrow to display the Product Control
Configuration screen. Refer to the Product Control section on page 99 for more information on product control
configuration.
Application Information. The Application Information displays the following information for the selected
product:
• Area per hour
• Pressure or fan speed - if an optional pressure transducer (P/N 422-0000-059) or fan speed sensor
(P/N 063-0171-277) has been installed
• Volume per minute
• Control status
• If a PWM or PWM Close valve is setup to control the selected product, the duty cycle of the PWM valve
appears in this area
To Next Page
Loading...
