112 E-Series Networked Display Reference Manual
Radar overlay
Overlaying the chart image with radar data allows for better distinction between
stationary and moving objects. For best results, switch on radar-chart synchronization.
You can customize the opacity setting for the overlaid image by twisting the rotary
controller.
If you have two radar scanners installed, select which one you want to use for the
overlay in the setup menu.
Note:
A radar image cannot be overlaid onto a chart window if dual-range is enabled
in the radar application.
To switch radar overlay on or off
1. Press the PRESENTATION softkey.
2. Press CHART LAYERS.
3. Toggle radar overlay on or off with the RADAR OVERLAY softkey.
To access radar and navigation options from the chart application
1. Press OK twice.
2. Select RADAR options or NAVIGATION OPTIONS with the appropriate softkey.
Using radar with the chart
You can combine the chart view with the following radar features:
• Radar range synchronization
•MARPA
•Radar overlay
Synchronizing chart scale with radar range
When synchronization is switched on:
The radar range changes to match the chart scale.
‘Sync’ is indicated in the top left-hand corner of the chart window.
If you change the radar range in any radar window, all synchronized chart views
change scale to match.
If you change the scale of a chart window, all radar windows change range to match.
To set radar range synchronization
1. Press the PRESENTATION softkey.
2. Press the CHART MODE AND ORIENTATION softkey.
3. Select the appropriate synchronization mode on the CHART SYNC softkey.
81244_4.book Page 112 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
