16 E-Series Networked Display Reference Manual
2.6 Initial setup procedures
When you first use your E-Series Display after it has been commissioned (see
Installation Guide), we recommend that you carry out the following:
• Selecting the data master (Networked E-Series Displays only).
• Set the language, the date and time format and preferred units of measurement.
• Select a page set.
• Select an application page/window.
• Adjust the display lighting.
Note: For full details of all System Setup options, please refer to Chapter 18:System set-
up and customizing. For application specific set up options, please refer to the appro-
priate chapter.
Selecting the data master (Networked E-Series only)
When a Networked E-Series system is powered on for the first time, an alarm will
sound and you will be asked to nominate which display is to be the data master. For
details of how to change the data master, please see
page 30
.
Setting the language, date/time format and units of mea-
surement
To adjust the language, date/time format and units of measurement to your preferred
settings:
1. Select the setting:
2. Adjust the setting:
3. Repeat this process until you have changed all of these settings.
Setup
System Setup...
Alarm Setup...
System Setup Menu
Date/Time Setup...
Units Setup...
System Integration Setup...
Waypoint Password Setup...
Position Made Lat/Lon...
D8504-1
Highlight
System Setup
Enter System
Setup
Highlight required
setting
Enter setting
MENU
D8505-1
Change value as
required
OK
or
Time Format 12hr
Local Time Offset UTC
Date/Time Setup Menu
dd/mm/yy
m
y
ate
ormat mm
y
e.g.
81244_4.book Page 16 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
