234 E-Series Networked Display Reference Manual
Graphical engine data
You can display engine tilt and trim data. You may need to set up a new page (or modify
an existing page set) for this data as an engine application window is not included in
the pre configured page sets.
To set up an engine data page
1. Press and hold the PAGE button.
2. Select the page set you want to edit by pressing its corresponding softkey.
3. Highlight your preferred page layout and press OK.
4. In the application list, highlight engine and press OK.
Refer to the E-Series Reference Manual for more details on setting up page sets.
Engine tilt and trim
To display engine tilt or trim data:
1. Press the MENU button to open the Setup screen from within the Engine monitor-
ing page.
2. Select Panel Setup Menu.
3. Select a configuration.
4. Press the SELECT DATA… softkey.
5. In the Data Groups window, select Engine.
6. Select Engine Tilt or Trim Tabs.
81244_4.book Page 234 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
