222 E-Series Networked Display Reference Manual
For a list of the softkeys available while the Autopilot Control screen is open, see
Table
10-3, Autopilot Control Toolbar
.
To go back to the Active Navigation screen without activating AUTO or TRACK, press
OK or CANCEL.
Note:
The STANDBY key replaces the REVIEW AND EDIT THIS ROUTE key.
10.4 Waypoint arrival
…when there are more waypoints in your route
The E-Series display:
• sounds the waypoint arrival alarm
• displays the Pilot Control screen, with information about the next waypoint
The toolbar gives you four options:
Press the ENGAGE PILOT -TRACK- softkey to engage the autopilot and continue to
the next waypoint in your route.
Press the CLEAR ALARM softkey to silence the alarm and keep the autopilot engaged
in auto mode, continuing on the current heading.
Press the STANDBY softkey to cancel the alarm and disengage the autopilot.
Press the AUTO softkey to cancel the alarm and engage the autopilot in auto mode.
Note:
If you make no selection within 30 seconds, the Next Waypoint alarm will sound.
Table 10-3: Autopilot Control Toolbar
AUTO Engage the autopilot and hold the current course (avail-
able when the autopilot is in Track or Standby mode).
ENGAGE PILOT
-TRACK-
Track to the current target waypoint.
STANDBY Disengages the autopilot (only available when the autopi-
lot is engaged).
81244_4.book Page 222 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
