132 E-Series Networked Display Reference Manual
For each preset (and for each frequency within the preset), you can change the
following display mode settings:
•Zoom
•Bottom Lock
•A-Scope
To change the settings for a preset
1. Press the ADJUST <preset name> softkey.
2. Select F1 or F2.
3. Select the mode you want to adjust.
4. Make changes using the trackpad or rotary controller.
5. Press OK when complete.
Zoom
If necessary you can zoom in on the bottom to display more detail.
This zoom option lets you:
• Replace the standard fishfinder image with the zoomed image, or display the
zoomed image alongside the standard fishfinder image.
• Set the zoom factor to a pre-defined level, or adjust it manually.
• Reposition the zoomed portion of the image to a different point in the display.
When the range increases, the area shown in the zoom window also increases.
Full or split screen
You can either replace the standard fishfinder image with the zoomed image or split
the screen and display the zoomed image alongside the standard fishfinder image
(ZOOM SPLIT). The zoomed section is indicated on the standard fishfinder screen by
a zoom box (see illustration below).
81244_4.book Page 132 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
