164 E-Series Networked Display Reference Manual
3. Set the magnification level for target expansion to LOW:
Note:
Selecting this option may compromise target resolution.
Wakes
When the wakes function is switched on, you can see the direction and speed of
moving targets relative to your boat. A target is displayed in yellow and as the signal
diminishes with time it is shown in paler shades of blue.
Note:
The wakes option is a local setting and will therefore only affect the individual
display on which you are working.
Displaying wakes
To switch on the wakes function:
Specifying the wake period
You can select via the Radar Setup Menu, whether these wakes are shown for periods
of 10 seconds, 30, seconds, 1 minute, 5 minutes or 10 minutes.
To specify the wake period:
1. Select ENHANCED ECHOS softkey.
2. Select WAKES softkey ON.
3. Select the time period you want to set.
4. Press OK.
Removing wakes
When the currently displayed wakes are no longer required they can be remove from
your screen by toggling WAKES to OFF.
ENHANCE
ECHOES...
WAKES
D8421_1
N
Toggle to ON
81244_4.book Page 164 Thursday, January 31, 2008 1:53 PM
To Next Page
Loading...
