To Next Page

To Previous Page

RED RAVEN OPERATION GUIDE

955-0127_V6.3, REV-E | 134

INPUT EXTERNAL TIMECODE

NOTE: This procedure requires a DSMC2 Base Expander, DSMC2 V-Lock I/O Expander, DSMC2 Jetpack

Expander, DSMC2 Jetpack-SDI Expander, or DSMC2 REDVOLT Expander. For more information, go to “Input/

Output Connectors” on page 167.

To input timecode generated by an external device, follow the instructions below:

1. Connect the external timecode generator to the camera:

‒ DSMC2 Base Expander, DSMC2 V-Lock I/O Expander, DSMC2 Jetpack Expander, or DSMC2 Jetpack-SDI Expand-

er: Connect the SYNC port (00B LEMO) on the expander to the device (yellow BNC) using a 3BNC-to-00

LEMO Sync Cable.

‒ DSMC2 REDVOLT Expander: Connect the GENLOCK port on the expander to the device using a 75 ohm

BNC cable.

2. Go to Menu > Settings > Project > Timecode.

3. Select the desired Timecode Display Mode.

4. Set Source to External.

The TC indicator in the Lower Status Row turns green when an external timecode source is locked.

NOTE: When an external source is selected but not present, timecode displays User Provided settings.

REQUIRED CABLE

 DSMC2 Base Expander, DSMC2 V-Lock I/O Expander, DSMC2 Jetpack Expander, or DSMC2 Jetpack-SDI Expander:

790-0154, 3BNC-to-00 LEMO

 DSMC2 REDVOLT Expander: 75 ohm BNC cable (such as the RED HD-SDI Cable, P/N 790-0341)

Source: External

Questions and Answers:

Need help?

Do you have a question about the RED Raven and is the answer not in the manual?

RED Raven Specifications

General