RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 77
SENSOR (FLIP/MIRROR SCAN DIRECTION)
The Flip/Mirror Scan Direction feature rotates the image 180°, both on the monitor and in the recorded R3D file.
Normally, the sensor scans the image from the top to the bottom. When the Flip/Mirror Scan Direction feature
is enabled, the sensor scan direction reverses, and the sensor scans the image from the bottom to the top.
The Flip/Mirror Scan Direction feature is intended for multi-camera arrays when all sensors are synchronized,
and at least one (1) camera is mounted upside-down. Using this feature is helpful for matching the line scan
direction for the cameras in the array.
To enable the Flip/Mirror Scan Direction feature, follow the instructions below:
1. Go to Menu > Settings > Project > Sensor.
2. Select the Flip/Mirror Scan Direction check box.
The camera rotates the image 180° on the monitor and in the recorded R3D file.
AUDIO
The Audio menu lets you configure the audio subsystem. For more information, go to “Record and Monitor
Audio” on page 127.
RECORDING
The Recording menu includes: Mode, Codec, Frame Processing, Pre-Record, and Indicator.
MODE
You can select the following recording modes: Continuous Record, Internal Timelapse Timer, Frame Trigger,
REDCODE Burst, Speed Ramp Mode, Multi-Shot, and Motion + Stills.
NOTE: Audio is recorded only in Continuous Record and Motion + Stills modes.
STORAGE
You can select the following storage locations:
Local: Stores footage directly to an SSD
Network: Stores footage to a network
NOTE: HDRx is disabled in Network Storage mode.
External: Stores footage to an external device
NOTE: In External storage, you can only select Continuous Record and Motion + Stills recording modes.
CONTINUOUS RECORD
NOTE: This mode is not available in Stills mode.
Continuous Record is the “normal” recording mode. The camera continuously records frames at the current
recording frame rate. You can limit each recording to a specific amount of frames using the Limit Recording to
setting.
To Next Page
Loading...
Need help?
General
