To Next Page

To Previous Page

RED RAVEN OPERATION GUIDE

955-0127_V6.3, REV-E | 78

INTERNAL TIMELAPSE TIMER

NOTE: This mode is not available in Stills mode.

NOTE: Audio is not recorded in Internal Timelapse Timer mode.

In Internal Timelapse Timer mode, the camera records a specified number of frames at a specified interval. The

current recording frame rate determines the timing of the frames per pulse.

For example, in Internal Timelapse Timer mode, you can choose to record a total amount of 1000 frames, and

take 1 frame every 4.67 seconds. After recording 1000 frames (which takes 4,670.00 seconds), the recording

process stops.

To use Internal Timelapse Timer mode, follow the instructions below:

1. Go to Menu > Settings > Recording > Mode.

2. Select Internal Timelapse Timer from the Mode drop-down menu.

3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).

4. Select the number of frames to be captured in the Record field.

5. Select the time interval from the Interval field (range is 1–3,599 sec). The Interval setting specifies the

frequency at which the frame or group of frames is captured.

6. Close the menu.

7. Start recording to start the interval.

The overlay displays the number of frames recorded out of the total amount of frames.

FRAME TRIGGER

NOTE: This mode is not available in Stills mode.

NOTE: Audio is not recorded in Frame Trigger mode.

In Frame Trigger mode, the camera records the specified number of frames for each external trigger. This mode

limits the REDCODE based on sustainable record rates.

To use Frame Trigger mode, follow the instructions below:

1. Go to Menu > Settings > Recording > Mode.

2. Select Frame Trigger from the Mode drop-down menu.

3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).

4. Select a Pre Count and Post Count. For more information, go to “Pre Count and Post Count” on page 80.

5. Close the menu.

6. Start recording.

The overlay displays the number of frames recorded out of the total amount of frames.

NOTE: There may be a delay between receiving the external trigger and capturing the next frame(s). The delay

may be as long one (1) frame period at the current recording frame rate. To completely synchronize frames to

an external trigger, set Sensor Sync Mode to MoCo. For more information, go to “Sync” on page 95.

RED Raven User Manual

Questions and Answers: