RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 87
FRAME SUMMING
Frame Summing combines the specified number of frames into one frame, and adds together the exposure time
for each of the original frames. The resulting frame has an effective integration time that is equal to the current
integration time multiplied by the number of frames.
For example, if you select 16 as the Frames to Process value, and set exposure to 1/48 sec, the resulting image
has an effective integration time of 1/3 sec (16 x 1/48).
Frame summing results in a final image that is brighter and possibly blurrier than any of the original frames, so
you can use frame summing to achieve the effect of long-exposure.
FRAME AVERAGING
Frame Averaging combines the specified number of frames into one frame, and averages the exposure time
for each of the original frames. The resulting frame has an effective integration time that is equal to the current
integration time.
For example, if you select 16 as the Frames to Process value, and set exposure to 1/48 sec, the resulting image
still has the exposure value of 1/48 sec, along with the effect of long-exposure.
You can use frame averaging to achieve the effect of long-exposure along with the benefits of reduced noise.
However, frame averaging does affect motion blur characteristics.
PRE-RECORD
When enabled, the Pre-Record setting continuously captures a cache of footage before recording starts. Select
to have 4–30 seconds (incremented at two second intervals) of pre-record time added to the actual footage.
When Pre-Record is enabled, you will not miss the start of a shot by being a little slow on the trigger.
Pre-Record Duration: Select the pre-record time.
Always trigger Pre-Record before recording: When selected, Pre-Record always starts when recording starts:
A. Press PWR/REC to activate Pre-Record.
B. Press PWR/REC a second time to start recording.
C. Press PWR/REC a third time to stop recording.
Trigger Pre-Record Now: When selected, the Pre-Record menu closes and Pre-Record mode starts.
NOTE: Always perform a Secure Format before using Pre-Record. A Secure Format restores the SSD back to
factory out-of-box settings, and optimizes the SSD for Pre-Record.
NOTE: To use Pre-Record only for specific situations, map Pre-Record to a key (Menu > Settings > Setup > Keys
> Record: Start Pre-Record). For more information, go to “Keys” on page 88.
INDICATOR
Enable Sounds: Select this check box to enable sounds. Then select sounds for the following actions:
‒ Record Start
‒ Record Stop
‒ Mark Still Frame
EVF Tally Light: Select this check box to enable the EVF Record Tally LED on the EVF to illuminate red when
recording.
SSD Tally Light: Select this check box to enable the Record Tally LED on the media bay to illuminate red
when recording. For more information, go to “Media Bay LEDs” on page 16.
SETUP
The Setup menu includes: Keys, Date/Time, Communication, GPIO/Sync, Fan Control, Lens, and Motor Control.
To Next Page
Loading...
Need help?
General
