To Next Page

To Previous Page

RED RAVEN OPERATION GUIDE

955-0127_V6.3, REV-E | 94

B. Tap or select the Passphrase text box.

The Passphrase screen opens.

C. Type the passphrase to access the network.

D. Select OK.

9. To enable/disable DHCP, select IP Config and set up the IP settings. For more information on configuring

DHCP and IP settings, go to “Ethernet” on page 91.

10. Select Connect at the bottom of the WiFi screen.

The IP address of the access point displays at the bottom of the WiFi screen after the camera connects to

the access point.

11. Connect your device to the same wireless network that the camera is connected to. The steps in this

procedure depend on what type of device and operating system you are using. For example, if you are

connecting an iOS device, go to Settings > Wi-Fi, and select the wireless network.

The camera and your device are now connected.

12. To ensure that your app can communicate with the camera, ensure that there is a way to connect your app

to a specific camera. Since there may be multiple cameras in the area, select your specific camera in the

app itself.

Questions and Answers:

Need help?

Do you have a question about the RED Raven and is the answer not in the manual?

RED Raven Specifications

General