Robin
850
Workshop
Manual
Supplement
Cooling system
Description
The introduction
of
the S.U. carburettor and
water-heated manifold
now
used on the
Robin
850
has resulted in a new water hose
layout,
as
follows:
The by-pass hose from the thermostat housing
to
the water
pump
is deleted, and replaced
by
a hose connected from the thermostat housing
to
the manifold adaptor, and a hose connected
from the manifold adaptor
to
the water pump.
To drain the
cooling
system
Some
850
vehicles may have a radiator not
fitted
with
a drain plug. To drain a radiator
of
this type
it
is necessary
to
remove the bottom
hose. Take the opportunity
to
check the
condition
of
the hose before replacement.
Section
E
To Next Page
Loading...
