RL78/G13 APPENDIX A REVISION HISTORY
R01UH0146EJ0100 Rev.1.00 1064
Sep 22, 2011
(3/7)
Page Description Classification
CHAPTER 6 TIMER ARRAY UNIT
p. 329 Change of Table 6-2. Timer I/O Pins provided in Each Product (c)
p. 332 Change of 6.2 (1) Timer count register mn (TCRmn) (c)
p. 336 Change of caution in 6.3 (2) Timer clock select register m (TPSm) (c)
p. 338 Addition of note to Table 6-4. Interval Times Available for Operation Clock CKSm2 or CKSm3 (c)
p. 339 Change of caution in 6.3 (3) Timer mode register mn (TMRmn) (c)
p. 340 to 343 Change of Figure 6-8. Format of Timer Mode Register mn (TMRmn) (c)
p. 345 Change of description in 6.3 (5) Timer channel enable status register m (TEm) (c)
p. 346 Change of description in 6.3 (6) Timer channel start register m (TSm) (c)
p. 353 Change of Figure 6-18. Format of Input Switch Control Register (ISC) (c)
p. 357 Addition of remark to 6.3 (15) Port mode registers 0, 1, 3, 4, 6, 10, 14 (PM0, PM1, PM3, PM4,
PM6, PM10, PM14)
(c)
p. 359 Change of description in 6.4.1 Basic rules of simultaneous channel operation function (c)
p. 369 Change of description in 6.5.2 (e) Start timing in capture & one-count mode (when high-level
width is measured)
Change of Figure 6-27. Start Timing (In Capture & One-count Mode)
(c)
p. 373 Change of Figure 6-30. TOmn Pin Output Status at Toggle Output (TOMmn = 0) (c)
p. 381, 382,
388, 397,
401, 403,
405, 412,
419, 427
Change of note in Figure 6-37, Figure 6-39, Figure 6-43, Figure 6-51, Figure 6-55, Figure 6-57,
Figure 6-59, Figure 6-64, Figure 6-69, Figure 6-74
(c)
p. 382, 388,
397, 401,
405
Change of operation clock (fMCK) selection in Figure 6-39, Figure 6-43, Figure 6-51, Figure 6-55,
Figure 6-59
(c)
p. 395, 400 Addition of note to Figure 6-49, Figure 6-53 (c)
p. 403 Change of description in 6.7.6 Operation as delay counter (c)
p. 430 Addition of 6.9 Cautions When Using Timer Array Unit (c)
CHAPTER 7 REAL-TIME CLOCK
p. 431
Change of caution in 7.1 Functions of Real-time Clock (c)
p. 432
Change of figure and caution in Figure 7-1. Block Diagram of Real-time Clock (c)
p. 434
Deletion of caution 4 of 7.3 (1) Peripheral enable register 0 (PER0) (c)
p. 435
Change of caution in 7.3 (2) Operation speed mode control register (OSMC) (c)
p. 438
Change of Figure 7-5. Format of Real-time Clock Control Register 1 (RTCC1) (2/2) (c)
p. 439, 440,
442 to 444
Change of description and caution in 7.3 (5) Second count register (SEC) to 7.3 (11) Year
count register (YEAR)
(c)
p. 450
Change of description in 7.4.3 Reading/writing real-time clock (c)
p. 451
Addition of caution 2 to Figure 7-20. Procedure for Writing Real-time Clock (c)
p. 453
Change of Figure 7-22. 1 Hz Output Setting Procedure (c)
CHAPTER 8 INTERVAL TIMER
p. 457
Change of description in 8.1 Functions of Interval Timer (c)
p. 460
Change of caution 1 in Figure 8-4. Format of Interval Timer Control Register (ITMC) (c)
Remark “Classification” in the above table classifies revisions as follows.
(a): Error correction, (b): Addition/change of specifications, (c): Addition/change of description or note,
(d): Addition/change of package, part number, or management division, (e): Addition/change of related
documents
To Next Page
Loading...
Need help?
General
