DURADRIVE Drive Controllers Replacing or Exchanging Drive Components 11-1
DOK-DURADR-HDC01.1****-PR02-EN-P
11 Replacing or Exchanging Drive Components
11.1 General
The diagnostic display of DURADRIVE enables an aimed and effective
problem search in order to:
• avoid production downtimes due to extensive searches in individual
units and repairs of units on the machine
• assume operations without extensive assembly and adjustments
• to quickly eliminate the problem, and replace the defective component
When returning a defective unit to Indramat Customer Service, please
complete the Fault Report in its entirety. This fault report is at the end of
this section and may be copied for your convenience.
Note: The new drive components must have the same type
designations as the old! To ensure this, register the entire type
designation when requesting a replacement part.
Position of the type plates:
The type plate of the DURADRIVE controller is situated behind the
protective cover at the housing. It lists all significant data.
The cooling fan units of the DURADRIVE controllers have their own type
plates.
The type plate of the MKD resp. MHD motors on the right side of the
motor (when looking onto the drive shaft, terminal box of the motor cable
on top).
Standard cables are labelled (cable mark). It bears the order number an
the length of the cable.
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
