DURADRIVE Drive Controllers Attachment 12-3
DOK-DURADR-HDC01.1****-PR02-EN-P
12.2 What is needed to prepare to start-up
To start up an drive system, the following is needed:
• Measuring equipment
• A PC
• Linking cables (PC-drive controller)
To be able to read off torque, current and velocity in the form of analog
signals at the analog outputs, the following measuring equipment is
needed:
• Multimeter to take voltage readings (suffices with a serial start-up)
• Oscilloscope or plotter (only needed to record signal paths when
commissioning a prototype)
The PC is needed to program, parameterize and diagnose when starting
up and servicing.
Hardware requirements:
• IBM compatible
• min. 80486 microprocessor (Pentium 166 or higher recommended)
• at least 16 MB RAM memory
• hard drive with at least 25 MB available memory
• CD-ROM drive
• A free serial RS232 interface on the PC (COM 1 or COM 2)
Software pre-requisites:
• Windows 95/98, NT4.0
• DriveTop start-up program
4-11, X2, Serial interface
Measuring devices
Personal computer (PC)
Link cables (PC-drive controller)
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page