Ricoh Aficio 1515 - Page 110

SERVICE PROGRAM 9 March 2004
5-12
Line Width Correction
4927*
Adjusts the line width correction algorithm. Positive settings produce thicker lines;
negative settings produce thinner lines. This setting is only applied to the originals
in SP4-921.
4927 1 Copy [–2 ~ 2 /
0
/ 1/step]
Independent Dot Erase
4928*
Selects the dot erase level. Higher settings provide greater erasure. This setting is
only applied to the originals in SP4-921.
4928 1 Copy [–2 ~ 2 / 0 / 1/step]
4929*
Positive/Negative [
0
= No, 1 = Yes]
4929 1 Copy
Inverts white and black. This setting is only
applied to the originals in SP4-921.
4930* Sharpness-Edge [–2 ~ 2 / 0 / 1/step]
4930 1 Copy
Adjust the clarity. This setting is only applied to
the originals in SP4-921.
4931*
Sharpness-Solid [–2 ~ 2 /
0
/ 1/step]
4931 1 Copy
Adjust the clarity. This setting is only applied to
the originals in SP4-921.
4932*
Sharpness-Low ID [–2 ~ 2 /
0
/ 1/step]
4932 1 Copy
Adjust the clarity. This setting is only applied to
the originals in SP4-921.
4941* White Line Erase [0 ~ 2 / 1 / 1/step]
4941 1 Selects the white line erase level.
0: None 1: Weak 2: Strong
• This setting is effective only Photo 1, Photo 3, Special 3 or Special 4 mode.
• 0: White line erase is not used, and white level correction is used instead·
•
This setting is applied regardless of what mode has been selected in SP4-921.
4942* Black Line Erase [0 ~ 3 / 2 / 1/step]
4942 1
Selects the black line erase level. This setting is effective only when originals are
scanned by the ADF.
[0 = No / 1 = Very weak / 2 = Weak / 3 = Strong]
This setting is applied regardless of what mode has been selected in SP4-921.