BIT SWITCHES 9 March 2004
3-16
System Switch 1F SP No. 1-101-032
No FUNCTION COMMENTS
0 Not used Do not change the setting.
1 Report printout after an original
jam during SAF storage or if
the SAF memory fills up
0: Enabled
1: Disabled
0:
When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to “1” if the customer does not want
to have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2
Not used Do not change the setting.
3
Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately after
the machine receives it.
1: The machine prints the complete message after
the machine receives all the pages in the memory.
4-6 Not used Do not change the factory settings.
7 Action when a fax SC has
occurred
0:
Automatic reset
1: Fax unit stops
0:
When the fax unit detects a fax SC code other
than SC1201, the fax unit automatically resets itself.
1:
When the fax unit detects any fax SC code, the
fax unit stops.
Cross Reference
Fax SC codes - See “Troubleshooting”
To Next Page
Loading...
