BIT SWITCHES 9 March 2004
3-20
Printer Switch 08 - Not used (Do not change the settings.)
Printer Switch 09 - Not used (Do not change the settings.)
Printer Switch 0A
- Not used (Do not change the settings.)
Printer Switch 0B
- Not used (Do not change the settings.)
Printer Switch 0C
- Not used (Do not change the settings.)
Printer Switch 0D - Not used (Do not change the settings.)
Printer Switch 0E SP No. 1-103-015
No FUNCTION COMMENTS
0
Paper size selection priority
0: Width
1: Length
0: A paper size that has the same width as the
received data is selected first.
1: A paper size which has enough length to print all
the received lines without reduction is selected first.
1
Paper size selected for
printing A4 width fax data
0: 8.5" x 11" size
1: A4 size
This switch determines which paper size is selected
for printing A4 width fax data, when the machine has
both A4 and 8.5" x 11" size paper.
2
Page separation
0: Enabled
1: Disabled
1: If all paper sizes in the machine require page
separation to print a received fax message, the
machine does not print the message (Substitute
Reception is used).
After a larger size of paper is set in a cassette, the
machine automatically prints the fax message.
3
to
4
Printing the sample image on
reports
Bit 4 Bit 3 Setting
0 0 The upper half
only
0 1 50% reduction
in sub-scan only
1 0 Same size
1 1 Not used
“Same size” means the sample image is printed at
100%, even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set to
“0” to enable this switch.
Refer to Detailed Section Descriptions for more on
this feature.
5-6
Not used Do not change the settings.
7
Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken place.
Other pages are printed without reduction.
To Next Page
Loading...
