9 March 2004 BIT SWITCHES
3-23
Service
Tables
Communication Switch 02 SP No. 1-104-003
No FUNCTION COMMENTS
0 Burst error threshold
0: Low 1: High
If there are more consecutive error lines in the
received page than the threshold, the machine will
send a negative response.
The Low and High threshold values depend on the
sub-scan resolution, and are as follows.
Resolution 100 dpi 200 dpi 400 dpi
3.85 l/mm 7.7 l/mm 15.4 l/mm
Low settings 6 12 24
High settings 12 24 48
1
Acceptable total error line ratio
0: 5% 1: 10%
If the error line ratio for a page exceeds the
acceptable ratio, RTN will be sent to the other end.
2
Treatment of pages received
with errors during G3 reception
0: Deleted from memory
without printing
1: Printed
0: Pages received with errors are not printed.
3
Hang-up decision when a
negative code (RTN or PIN) is
received during G3 immediate
transmission
0:
No hang-up,
1:
Hang-up
0: The next page will be sent even if RTN or PIN is
received.
1:
The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
4-7 Not used Do not change the settings.
Communication Switch 03 SP No. 1-104-004
No FUNCTION COMMENTS
0
to
7
Maximum number of page
retransmissions in a G3
memory transmission
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
Communication Switch 04 - Not used (Do not change the settings.)
Communication Switch 05 - Not used (Do not change the settings.)
Communication Switch 06
- Not used (Do not change the settings.)
Communication Switch 07
- Not used (Do not change the settings.)
Communication Switch 08 - Not used (Do not change the settings.)
Communication Switch 09 - Not used (Do not change the settings.)
Communication Switch 0A SP No. 1-104-011
No FUNCTION COMMENTS
0
Point of resumption of memory
transmission upon redialing
0: From the error page
1: From page 1
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page, using
normal memory transmission.
1-7
Not used Do not change the settings.
To Next Page
Loading...
