• The protocol is set to inactive as default. Enable the protocol on the control panel, using Web
Image Monitor, SmartDeviceMonitor or telnet.
Notes when using NetWare
Form Feed
Do not use NetWare to configure form feed. Form feed is controlled by the printer driver on
Windows. If NetWare form feed is configured, the printer may not print properly.
Follow the procedure below to disable form feed according to the operating system used:
• Clear the [Form feed] check box on the [NetWare Settings] tab in the printer properties dialog
box.
Banner Page
Do not use NetWare to configure banner page.
Follow the procedure below to disable banner page according to the operating system used:
•
Clear the [Enable banner] check box on the [NetWare Settings] tab in the printer properties
dialog box.
When using the PostScript 3 Printer Driver
Follow the procedure below to set up the PostScript 3 printer driver.
1. Open the printer window.
• Windows XP, Windows Server 2003/2003 R2:
On the [Start] menu, select [Printers and Faxes].
• Windows Vista, Windows Server 2008:
On the [Start] menu, select [Control Panel], and then click [Printers] in [Hardware and
Sound] category.
• Windows 7, Windows Server 2008 R2:
On the [Start] menu, select [Devices and Printers].
2. Open the printer properties dialog box.
• Windows XP/Vista, Windows Server 2003/2008:
Right-click the machine's icon, and then click [Properties].
• Windows 7, Windows Server 2008 R2:
Right-click the machine's icon, and then click [Printer properties].
3. Click the [Device Settings] tab.
4. Select [No] on the [Send CTRL-D Before Each Job:] and [Send CTRL-D After Each Job:], and
then click [Apply].
Installing the Printer Driver for a Network Connection
25
To Next Page
Loading...
Need help?
General
