Enter remote printer name [default lp]:text
You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red Hat Linux 7.0, and
51 for Red Hat Linux 6.2.
After setup with the installation shell script is complete, and if you entered the IP address in step 4,
the following message appears:
hosts file is modified
8. Perform a test print to make sure that the settings are correct.
# lpr -Pnp file_name
# lp -d np file_name
• SunOS, UnixWare, and OpenServer appear on the screen, but they are not supported. Use
Solaris, HP-UX, or Linux.
• The IP address will be added to the /etc/hosts file.
•
The host name will be added to the /etc/hosts file.
• When printing with the lp command, use ( _ ) instead of ( = ) and ( ; ) instead of ( , ) for operating
systems that cannot use ( = ) and ( , ) such as Solaris 2.5 or later.
• For details about how to download the installation shell script, contact your sales or service
representative.
• For details about lpr and lp, see p.17 "Printing Method".
• For details about the device option, see p.22 "Specifying the Device Option".
Deleting the printer
To print using the lp or lpr command, the option specified when the installation shell script is executed is
used. Change the option in accordance with the workstation you are using.
BSD UNIX workstation, Linux
Delete the printer entry from /etc/printcap, and then execute the installation shell script again.
Select options during the setup process.
Alternatively, search the printer entry from /etc/printcap, and change its rp capability to option
setting.
Solaris, HP-UX
Delete the printer entry, and then execute the installation shell script again.
Select options during the setup process. To delete the printer entry, follow the procedure below:
1. Stop the scheduler.
# /usr/sbin/lpshut
2. Delete the printer.
Using the Installation Shell Script
11
To Next Page
Loading...
Need help?
General
