11. Select the "Printer Job Authentication" level.
For a description of the printer job authentication levels, see p.64 "Printer Job Authentication".
If you select [Entire] or [Simple (All)], proceed to step 15.
If you select [Simple (Limitation)], proceed to step 12.
12. Press [Change].
13. Specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication".
You can specify the IPv4 address range to which this setting is applied, and whether or not to apply
the setting to the parallel and USB interfaces.
14. Press [Exit].
15. Press [OK].
User Code Authentication
35
To Next Page
Loading...
