Ricoh Aficio MP C5502 User Manual

Setting Description Setting value
Remote Address
Specify the address of the
IPsec transmission partner.
You can also specify an
address range.
The IPsec transmission
partner's IPv4 or IPv6 address.
If you are not setting an
address range, enter 32 after
an IPv4 address, or enter 128
after an IPv6 address.
Security Policy Specify how IPsec is handled.
• Apply
•
Bypass
• Discard
Encapsulation Mode
Specify the encapsulation
mode.
(auto setting)
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
Select the transport mode (this
has no bearing on the security
level).
If you specify "Tunnel", you
must then specify the "Tunnel
End Point", which are the
beginning and ending IP
addresses. Set the same
address for the beginning
point as you set in "Local
Address".
IPsec Requirement Level
Specify whether to only
transmit using IPsec, or to
allow cleartext transmission
when IPsec cannot be
established.
(auto setting)
• Use When Possible
•
Always Require
5. Enhanced Network Security
154

Ricoh Aficio MP C5502 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Max Print Resolution	1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Multiple Copy	Up to 999 copies
Max Paper Capacity	4, 400 sheets
Duplex Printing	Yes
Hard Disk Drive	250 GB
Power Consumption (Maximum)	1.7 kW
Type	All in One Printer
Print Speed	55 pages per minute
Copy Speed	55 copies per minute
Zoom	25% to 400%
Scan Resolution	600 dpi
Fax Resolution	200 x 200 dpi
Original Capacity	100 sheets
Standard Paper Capacity	1, 200 sheets
Memory	1.5 GB RAM
Interface	USB 2.0, Ethernet
Network Protocols	TCP/IP
Operating Systems Supported	Windows, Mac, Linux
Power Source	AC 120V, 60Hz
Paper Weight	52 – 256 g/m²