Using Connect Copy
89
3
❒ When the number of originals
or copies is small, copying will
be done on only the main ma-
chine.
F
FF
F
Press the {
{{
{Start}
}}
} key on the main
machine.
Copying starts on the main ma-
chine after the originals are
scanned.
Copying starts on the sub-machine
when data transfer from the main
machine is completed.
Setting originals on the exposure
glass
A Set the next original when the
machine has finished scanning
the first. Press the {
{{
{Start}
}}
} key.
B When all the pages have been
scanned, press the {
{{
{#}
}}
} key.
Note
❒ If the machine is not in use, it
will begin copying.
Using Batch mode
A Place the originals and press
the {
{{
{Start}
}}
} key.
B After the first set of originals
has been fed, place the next set.
Note
❒ The next set of originals must
be set while the Auto Feed
indicator is lit.
❒ To stop scanning or copying,
press the {
{{
{Clear/Stop}
}}
} key on
the main machine, and then
follow the instructions on the
display.
Reference
p.16 “Batch”
C Collect your copies from both
the main and sub machines.
Note
❒ The number of copies might
differ on the main and sub
machines.
❒ Both machines may not fin-
ish copying at the same time.
❒ When using the Sort/Staple
function, copying is divided
between the two machines
by the number of sets. If a pa-
per misfeed occurs when
processing a set of copes, it is
not possible for the other ma-
chine to take over the re-
mainder of that particular
set.
-
--
-Order of Copy Output
❖
❖❖
❖ When copying with the Sort/Staple
function
(Example) Copying 6 sets of a
three-page original
1.
Main machine
2.
Sub-machine
Copies are delivered face-down on
both the main and sub machines.
When using the Sort/Staple func-
tion, the processing of one copy set
cannot be divided between the two
machines.
< 1 > < 2 >
MartiniC2_EN_Copy-F1_FM.book Page 89 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
