Ricoh DSm651 - Page 320

User Tools (Copier/Document Server Features)
134
5
❖
❖❖
❖ SADF Auto Reset
In SADF mode, an original must be
set within a specific time after the
previous original has been fed.
You can adjust this time from 3 sec-
onds to 99 in 1 second increments.
Note
❒ Default: 5 seconds
❖
❖❖
❖ Rotate Sort: Auto Paper Continue
You can continue copying when
paper of the required orientation
has run out during rotate-sorting.
See p.34 “Rotate Sort”.
Note
❒ If you select [No] :
• When paper of the required
orientation runs out, the ma-
chine stops copying and
prompts you to supply copy
paper. When you load paper,
the machine will continue
copying.
❒ If you select [Yes] :
• Copying continues using
copy paper of a different ori-
entation. The copy job will
finish even if the machine is
left unattended.
❒ Default: No
❖
❖❖
❖ Auto Sort
You can specify whether the Sort
function is to be selected when the
machine is turned on, or when the
functions are cleared.
Note
❒ Default: No
❖
❖❖
❖ Memory Full Auto Scan Restart
If memory becomes full while
scanning originals, the machine
will copy the scanned originals
first, and then automatically pro-
ceed scanning remaining originals.
You can enable or disable this
function.
Note
❒ If you select [No] :
• When memory becomes full,
the machine stops operation,
allowing you to remove the
copies on the output tray.
❒ If you select [Yes] :
• You can leave the machine
unattended to make copies,
but sorted pages will not be
sequential.
❒ Default: No
❖
❖❖
❖ Select Stapling Position (Top Left)
Specify which the type of stapling
to be shown on the top left key of
the initial display.
Note
❒ Default: Top
❒ The optional finisher is required
to use this function.
❖
❖❖
❖ Select Stapling Position (Bottom Left)
Specify which the type of stapling
to be shown on the bottom left key
of the initial display.
MartiniC2_EN_Copy-F1_FM.book Page 134 Tuesday, July 27, 2004 1:43 PM