Printer Features Parameters
119
5
❖
❖❖
❖ Stapling Type
You can set the default staple type
if the machine cannot find the
printer language automatically.
• Off
• Top Left Slant
• Top Right Slant
• Left 2
• Top 2
• Right 2
• Top Left
• Top Right
• Center
Note
❒ Default: Off
❒ This menu appears only when a
finisher (optional) is installed.
Reference
For details, see p.88 “Staple”.
❖
❖❖
❖ Punch Type
You can set the default punch type
if the machine cannot find the
printer language automatically.
• Off
• Left 2
• Top 2
• Right 2
• Left 3
• Top 3
• Right 3
• Left 4
• Top 4
• Right 4
Note
❒ Default: Off
❒ This menu appears only when
the optional punch is installed.
❒ Displayed items will differ de-
pending on the finisher type, the
original's orientation, the paper
size, and the orientation type.
Reference
For details, see p.90 “Punch”.
Host Interface
❖
❖❖
❖ I/O Buffer
You can set the size of the I/O
Buffer. Normally it is not neces-
sary to change this setting.
• 128 KB
• 256 KB
• 1 MB
Note
❒ Default: 128 KB
❖
❖❖
❖ I/O Timeout
You can set how many seconds the
machine should wait before end-
ing a print job. If data from another
port usually arrives in the middle
of a print job, you should increase
this timeout period.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Note
❒ Default: 15 seconds
MartiniC25-EN-Pref-F_FM_ZF.book Page 119 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
