Troubleshooting
139
8
Exceeded max. pages. Collate
is incomplete.
The maximum number of pag-
es has been exceeded for colla-
tion.
Turn off the main power
switch, and back on again. Re-
duce the number of pages to
be printed. If the message ap-
pears again, contact your sales
or service representative.
HDD has a problem. An error has occurred in the
hard disk drive.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Data storage error. Locked Print was performed
without the hard disk in-
stalled, or the hard disk is
damaged.
Contact your sales or service
representative.
HDD is full. The maximum hard disk area
size for form/font has been ex-
ceeded.
Delete unused form / font
types.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
Delete some stored files, or re-
duce the size of the file to be
downloaded.
dLower staple is almost
empty.
There are only a few staples
left in the lower stapler.
Load more staples.
NV-RAM has a problem. An error has occurred in the
NV-RAM.
Turn off the main power
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
Output tray has been
changed.
The output tray has been
changed because of the paper
size limitation of the selected
tray.
Select the correct output tray.
Paper in staple tray. Open
Finisher Cover and remove
paper.
There is paper remaining in-
side the finisher.
Open the cover of the finisher,
and remove the paper.
Parallel I/F board has a prob-
lem.
An error has occurred in the
parallel interface board.
Contact your sales or service
representative.
Print overrun. The image data has been
thinned out due to image com-
pression.
Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Problems with the wireless
board.
An error may have occurred in
the IEEE 802.11b interface
unit.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Problems with the wireless
card.
An error may have occurred in
the IEEE 802.11b interface
unit.
Messages/Second messages Causes Solutions
MartiniC25-EN-Pref-F_FM_ZF.book Page 139 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
