Ricoh DSm651 - Page 554

Connecting and Setting Up
36
2
❖
❖❖
❖ WINS Configuration
You can specify the WINS server
settings.
• On
If [On] is selected, enter the
[V
VV
VWINS Server] IP address as
“xxx.xxx.xxx.xxx”(“x” indi-
cates a number).
If DHCP is in use, specify the
[Scope ID].
• Primary WINS Server
• Secondary WINS Server
• Scope ID
• Off
Limitation
❒ Enter a [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: Off
❖
❖❖
❖ Effective Protocol
Select the protocol to use in the
network.
• TCP/IP:Effective/Invalid
• NetWare:Effective/Invalid
• SMB:Effective/Invalid
• AppleTalk:Effective/Invalid
Note
❒ Default: TCP/IP: Effective, Net-
Ware: Effective, SMB: Invalid, Ap-
pleTalk: Effective
❖
❖❖
❖ NW Frame Type
Select the frame type when you
use NetWare.
• Auto Select
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
Note
❒ Default: Auto Select
❖
❖❖
❖ SMB Computer Name
Specify the SMB computer name.
❖
❖❖
❖ SMB Work Group
Specify the SMB work group.
❖
❖❖
❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your
network environment. [Auto Select]
should usually be selected.
• Auto Select
• 100Mbps Full Duplex
• 100Mbps Half Duplex
• 10Mbps Full Duplex
• 10Mbps Half Duplex
Note
❒ Default: Auto Select
❖
❖❖
❖ LAN Type
When you have installed the op-
tional IEEE 802.11b interface unit,
select interface, IEEE 802.11b
(wireless LAN) or Ethernet.
• Ethernet
• IEEE 802.11b
Note
❒ Default: Ethernet
❒ Appears when the optional IEEE
802.11b interface unit is in-
stalled.
❒
If Ethernet and IEEE 802.11b (wire-
less LAN) are both connected to
the machine, the selected inter-
face takes precedence.