G147 4-32 SM
SP9503 004 DFU 51 to 255 SP9503 004 DFU
SP9508 001 DFU 51 to 255 SP9508 001 DFU
SP9508 002 DFU 51 to 255 SP9508 002 DFU
SP9517 002 DFU 401 to 802 SP9517 002 DFU
- Recovery from SC980 -
Continued use of the machine with one or more of the SP codes listed above out of range
could lead to toner overflow or other problems that could cause damage to the machine.
1. Enter the SP mode and check the setting of SP2802 001, 002, 003.
2. If these SP codes are within range, turn the machine power off and on.
- or -
If one or more of these SP codes is out of range, do SP2801 001 (TD Sensor Initial
Setting) then turn the machine power off and on.
3. Enter the SP mode and do SP5990 001 (SMC Printout – SP Mode Data List).
4. Check the following SP codes and confirm that their settings are within range.
SP No. Name Range
2005 004 Charge Roller Voltage Adjustment 2 -1000 to -2000 V
SP2802 001 TD Sensor Manual Setting – VTS
SP2802 002 TD Sensor Manual Setting – VTMAX
SP2802 003 TD Sensor Manual Setting – VTMIN
1.00 to 5.00 V
Print image data transfer error
984 D
The image transfer from the controller to the
engine via the PCI bus does not end within 15
s after starting.
Controller board
defective
BICU defective
Connectors between
BICU and controller
loose or defective
986 D Software write parameter setting error Software defective
To Next Page
Loading...
