Ricoh MET-C1 - Page 498

SC No. Level Error Name/Error Condition/Major Cause/Solution
• Lift motor error/connector missing
• Lower limit sensor error/connector missing
• Harness broken
• Bank control board defective
• Paper set fault
• Timing belt damage/dropout
• Timing pulley damage/dropout
• Base plate damage/horizontality fault
• Foreign matter, such as paper scrap, is caught inside the tray
• Reset the paper
• Remove the foreign matter
• Replace the motor
• Reset the connector
• Replace the harness
• Replace the sensor
• Replace the control board for the optional side LCT
• Replace the tray
• Replace the timing belt
• Replace the timing pulley
• Replace the base plate
5. Troubleshooting
496