The procedure is explained using Windows 7 as an example.
Logging in using a printer driver
1. Open the printer properties dialog box, and then click the [Advanced Options] tab.
2. Select the [User Authentication] check box.
3. If you want to encrypt the login password, click [Driver Encryption Key...].
If you do not want to encrypt the password, proceed to Step 6.
4. Enter the driver encryption key already set on the machine.
5. Click [OK] to close the [Driver Encryption Key] dialog box.
6. Click [OK] to close the printer properties dialog box.
7. From the [Print] window, open the printing preferences dialog box.
8. Specify the user authentication setting.
If you are using the PCL 5e printer driver, click the [Valid Access] tab, and then click
[Authentications...].
If you are using the PCL 6 printer driver, click the [Detailed Settings] tab, click [Job Setup],
and then click [Authentication...] in the [Job Setup] area.
9. Enter a login user name and login password already set on the machine or the server
for user authentication.
Be sure to enter the same login user name and login password that is registered on the
machine or the server.
If you do not enter a valid login user name and login password, printing will not start.
10. Click [OK] to close the [Authentication] dialog box.
11. Click [OK] to close the printing preferences dialog box.
• Depending on the application in use, the properties specified in this procedure may not take
effect.
• If you log in using the driver, you do not need to log out when you finish.
Logging In Using Web Image Monitor
This section explains the procedure for logging in to the machine via Web Image Monitor.
1. Open a web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
4. Getting Started
140
To Next Page
Loading...
