• The container can hold up to 380 g (0.84 lb.) of glue (about two of the provided cups).
• You can change the glue heating time under [Binding Glue Heater Auto Off Timer] in [System
Settings]. For details, see "Timer Settings", Device Management.
• The glue requires up to 6.5 minutes before the binding can begin. To begin binding quickly, be
sure to press the glue temperature adjustment key in advance.
Where to Put Your Machine
This section describes precautions for installation and movement.
Moving the machine
This section describes precautions when moving the machine.
Choose your machine's location carefully.
Environmental conditions greatly affect its performance.
• Contact your service representative if you need to lift the machine (such as when relocating it to
another floor). Do not attempt to lift the machine without the assistance of your service
representative. The machine will be damaged if it topples or is dropped, resulting in
malfunction and risk of injury to users. The machine's various handling areas are for service
engineer use only. Do not touch these areas.
• Contact your sales representative before moving the machine out of the building or to another
location in the building. A moving service can be provided for a fee.
Optimum Environmental Conditions After Moving the Machine
Optimum environmental conditions
• Be sure to locate the machine as close as possible to a wall outlet. This will allow easy
disconnection of the power cord in the event of an emergency.
General Requirements
529
To Next Page
Loading...
